Clay separator on centrifuge basis

Clay separator on a centrifuge basis is designed for treatment of drilling weighted and nonweighted muds from excessive clay amount and a regeneration of weighted muds when drilling of gas and oil wells.

Its basic unit is a horizontal settling centrifuge with sediment scroll-discharge.
Separation of solid phase from liquid one takes place due to centrifugal forces when the drilling mud delivering into the centrifuge; discharge and the centrifuge effluent drain (clarified liquid phase) are made continuously.
This plant is complete with a conveyer, providing sediment removal out its boundaries.
The pump unit incorporates screw conveyer pump, which is motor driven through a V-belt drive. All assemblies are mounted on one frame.
The pouring-over device is by-pass, permitting to adjust mud supply into the centrifuge with a constant mud supply by a pump unit due to partial mud discharge into the tank.
The homogenizer provides uniform mass of a dewatered sediment receiving.

Specifications

Volumetic feed of initial product for a clay separator, m3/h, no more than: 
          when removing clay from weighted mud with a density to 1.1 g/cm3 18
          when regenerating weighted mud with a density:
                      to 1.5 g/cm3
                      to 2.0 g/cm3
6
3
  Degree of clay removal, %, no less than80
  Degree of barytic weighting agent regeneration, %,n o less than90
  Maximum inner centrifuge diameter, mm500
  Ratio of rotor working length to inner diameter1.86
  Rated power, kW, no more than37
  Weight, kg, no more than   4000  

Main   |   Production   |   Production Potentialities   |   Quality system   |   Contact us